Call to get tree service such as tree romoval,


stump grinding, bush trimming, shrub mulching


or resolve any other tree related issues now:




Call now +1 (855) 280-15-30



Once they are removed, it is important to push them evenly.



This Schwaben Rear Axle Bushing Tool Set (Mfg#SCH01A) fits Volkswagen /20AE, Volkswagen Golf IV, Volkswagen Jetta IV, Volkswagen Jetta IV GLI, Volkswagen New treecutter.pw: Schwaben.



Removing rear axle bushes.



Finally available at IDParts, this rear axle bushing tool makes pressing in new rear axle bushings a breeze. Works on all MkIV Golf, Jetta and New Beetle. Uses two large, fitted plates to squeeze the bushing into the axle without needing to remove the axle or use a press! Plates are squeezed together by a threaded rod (similar to a rear brake tool).5/5(4).



Aye I hacksawed the bush once I had the rubber part out Used a drill to break up the rubber first then bashed it out The drivers side is OK But the passengers side was a pain as I left the brake flexi on I marked where the bracket was and remove the bolts To let it drop down to give a bit more space I also fitted Polly bush's to make the job easier to do.



May 12, I've found various cheap VW mk4 golf, bora and A3 rear bush axle install tools out there but none like wise for the A2. Looking at the bush specs for the range it appears the length and circumference of the bushes are the same but the inner thread size of the bush appears to be 1mm bigger on the A2 bushes - 12mm versus 11mm (or mm depending on where you find the info). Jun 19, The Haynes should be able to guide you in dropping the axle Not sure of the exact bush you need but there are a few on eBay NEW MODIFIED Rear Axle Bushes Latest Version for VW Mk4 Golf & Bora & Audi A3 eBay VW MK4 GOLF AUDI A3 REAR AXLE BUSH BUSHES x2 1JC eBay Golf MK4, Audi A3, Vw Bora, Seat and Tree removal buffalo ny, Orlando FL Rear Axle Bush Mounting Tool.

Apr 02, mkiv Rear Axle Bush Install - posted in MkIV (Mk4) Golf & Bora: Hi, I just tried to do a rear axle bush install on axle stands on the drive.

I didnt even get anywhere near to removing the bushes because the flexible brake hoses between the body and the rear arms are way too short! The Haynes manual claims that you can disconnect them from their retaining clips in some way so that.

Oct 29, removing the old one is easy either burn it out or use a drill with a small bit and drill the rubber out then use a hacksaw to cut the outer coller and release the tension it should just pop out then. there is a good guide over on uk-mkivs. priceygti, Sep 5, #7.





© treecutter.pw | 1712 1713 1714 1715 1716 | Privacy Policy